Raked Cutter Rig

brian eiland

Senior Member
Joined
Jun 3, 2002
Posts
5,652
Reaction score
333
Location
St Augustine Fl, Thailand
How can I get into this link they provide??

Raked Cutter Rig

Brian wrote:
I found this discussion today on the web that I took the liberty to add to the forum discussion of cutter rigs, and to this aft mast discussion that features two raked headsails acting in a somewhat similar manner

Raked Cutter Rig by WindSpeedYachts.com

History.
Ever since 1851 when the Schooner America with her 11.5 degree mast rake won the America's cup, mast rake has been used to improve the performance of sail power as a propulsion method. Every high speed craft including land yachts, ice boats, windsurfers and racing Multihulls use mast rake to improve performance.
Yachts that race to a handicap don't use mast rake because it is penalized by the handicap rules. In handicap racing the fastest yacht is not the winner, the yacht that sails closest to her handicap is the winner. Our yachts are not designed to any racing rules they are designed to be safe, efficient and comfortable.
The cutter rig has historically been the rig of choice for the monohull cruising sailor.

The Modern Raked Cutter Rig.
In 1991 we proudly redeveloped and introduced the modern, efficient raked cutter rig into cruising Multihulls.

The Raked Cutter Rigs features:
+A 7.5 degree mast rake, the key to the whole modern cutter rig working so well:
+Parallel fore stays for the greatest cutter effect.
+The distance between the forestays is spaced for maximum sail efficiency.
+The Jib easily tacks between the stays.
+Low aspect ratio rig to increase stability, reduce rig loads and reduce pitching.
+Low centre of gravity, low wind resistance cruising rig.
+The stay sail is close to the deck which improves efficiency and pressurizes +the windward nets and lifts the leeward nets reducing on board spray and increases stability.
+With the roller furling Jib on the composite bowsprit, which is wide enough to walk on and the fully battened stay sail on the fore beam, the fore triangle is broken into two easily handled sails.
+The large fully battened mainsail is reduced in area by the mast rake.
+This long low sail plan increases stability, reduces the sail handling effort required by the crew and off the wind increases the power to propel the yacht.

Notes
This rig is the complete opposite approach to the trend for high aspect ratio fractional rigs being installed on cruising yachts.
We have observed the trend by designers and builders to increase the height of masts to "improve performance" however we are informed by boat owners that increased speeds are achieved by reefing the mainsail. This is not surprising, tall masts raise the centre of effort of the sailplan, this increases the heeling force which pushes the leeward hull further into the water increasing hull drag. If you look into the hull shapes, for example a 12 m catamaran with fat hulls 1.2 to 1.4 m wide on the water line and fixed keels, the drag on these hulls when the leeward hull is depressed increases considerably. This type of hullshape is happy with both hulls evenly floating while motoring or sailing down wind not being pressed hard to windward or reaching.
The high aspect ratio racing rig works exceptionally well on racing yachts however it does not make slow hull shapes fast hull shapes.
How does mast rake increase yacht speed?

The more horizontal the fore stay angle the greater the vertical lift generated by the jib. Effectively lifting the bows which reduces the yachts displacement which reduces wave drag and increases the yachts speed. Raking the mast aft has a similar effect to fore stay angle.

With a vertical mast the forces generated by the mainsail are forward and downwards but by raking the mast aft these forces are rotated to become forward and upward resulting in increased speed due to decreased displacement.

The effect of mast rake is apparent sailing to windward but far more obvious when reaching and running.

Because the bows are not driven down by sail pressure we can use finer bows which further reduce drag and pitching.

Another advantage of mast rake is reduced pitching caused by the lack of the pendulum effect.
With a vertical mast in a sea way the masts mass and momentum forces the bows and sterns up and down alternately greatly increasing the pitching.
With a raked mast in a sea the masts mass and momentum forces are rotated to force the bows forward and the sterns up and down alternately greatly reducing the pitching.

The combined effect of the lift generated from the raked cutter rig, the lift generated from the under wing, the extra buoyancy and dynamic lift generated by the inboard flair and the stabilizing effect of the rudder mounted foil combine to reduce heeling, under wing wave impacts, yacht motion and increases average speeds.

The Raked Cutter Rig of the WindSpeed 40 has proved to achieve higher average speeds than any other rig aboard a liveaboard cruising Multihull yacht yet encountered.

Test results
Test have been undertaken on many yachts over many years but the most convincing test was aboard a 2000 kg 10 metre racing Multihull with a 15 metre rotating mast. This yacht started life with a vertical mast, and over two years the mast was raked progressively aft with consistently improving performance. The lift generated by the raked mast allowed us to carry more sail area in stronger winds off the wind and when sailing to windward, the crew of four would sit forward of the mast to keep the bows down.

On a 1.5m long radio controlled test model trimaran the mast was raked so far aft that the model capsized bow over stern from the lift generated from mast rake!

Note: We were testing the feasibility of using surface effect wings for racing trimaran beams at the time and these foils may have contributed in the capsizes [tested in 1981]

Conclusion
Our theoretical calculations and practical testing indicate that the raked cutter rig on the WindSpeed 40 generates 240 kg of vertical lift in 18 knots of apparent wind and sailing to windward at 8 knots this reduction in displacement equates to approximately 0.1 knots extra yacht speed! The lift generated by the raked cutter rig increases as the sheets are eased which increases the improvements in downwind yacht speeds

(opinions of www.windspeedyachts.com.au)
 
Point one knots increase in headway is a significant proportion when talking about typical sailing speeds below 12 knots.

I am in favor of significant mast rake, but for a heeling vessel, that upward lift effect is lost once the plane of the sail is angles downward.
20210807_SAILING_RACE_FLATHEAD_5-1.jpg

For a catamaran, I can see how this would have a real benefit. Rake should also contribute to keeping the boat upright, less heeling.

The sailrocket takes this to extreme, and of course, the next step is the kite sail.

-Will
 
Good points Will,...and nice photo to emphasize same !!

On a level sailing (cruising cat) that bow suppression by the headsails is far less extreme,...almost like feeling lift
 
Last edited:
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making any potentially dangerous or financial decision, always employ and consult appropriate professionals. Your circumstances or experience may be different.
Back
Top