My boat project is a 11 ft L x 48"W planing hull micro-skiff, it is a Carbon fiber/Basalt fiber skinned foam blank. I have decided to build an electric surface drive I will be using a Maytech, MTI 120116 brush-less motor that puts out 18.8 KW max or about 25hp. I am building a motor and shaft unit that
pivots up and down to change the angle and depth of the prop and use a Levi drive type shroud/rudder for steering. The drive shaft will be 48" long or possibly a little longer if needed.
I am now at the point where I could use some advice on shaft design. The motor comes with a 15 mm shaft that I would have to couple to. I am considering a stainless tube for the drive shaft to run through and either bushings or bearings to reduce down to the drive shaft size.
What type of bushings or bearing would be best ?
Should I have one bearing at the top and one at the bottom end of the shaft or have a bearing in the middle?
Should I be using a cutlass bearing at the prop end of the shaft?
Should I use a thrust bearing at the motor end to keep from putting pressure on the internal motor bearings?
I have seen electric drive set ups for different applications where they used a curved jaw coupling to alleviate vibration and alignment issues, would that be advisable? Or should I consider 2 of these couplings in the drive design?
I also need to decide the prop end design, splined or threaded for prop attachment?
I'm pretty good on boat design and construction but I am pretty clueless about this shaft design problem and I am doing a lot of experimental stuff in my overall design and want to keep error in my drive trial and error to a minimum.
pivots up and down to change the angle and depth of the prop and use a Levi drive type shroud/rudder for steering. The drive shaft will be 48" long or possibly a little longer if needed.
I am now at the point where I could use some advice on shaft design. The motor comes with a 15 mm shaft that I would have to couple to. I am considering a stainless tube for the drive shaft to run through and either bushings or bearings to reduce down to the drive shaft size.
What type of bushings or bearing would be best ?
Should I have one bearing at the top and one at the bottom end of the shaft or have a bearing in the middle?
Should I be using a cutlass bearing at the prop end of the shaft?
Should I use a thrust bearing at the motor end to keep from putting pressure on the internal motor bearings?
I have seen electric drive set ups for different applications where they used a curved jaw coupling to alleviate vibration and alignment issues, would that be advisable? Or should I consider 2 of these couplings in the drive design?
I also need to decide the prop end design, splined or threaded for prop attachment?
I'm pretty good on boat design and construction but I am pretty clueless about this shaft design problem and I am doing a lot of experimental stuff in my overall design and want to keep error in my drive trial and error to a minimum.