fallguy
Boat Builder
- Joined
- Dec 7, 2016
- Posts
- 9,038
- Reaction score
- 2,119
- Location
- usa
So, I am using stitched triaxial 0/+/-45 fabric. I think rxcomposite is the local expert on this subject, but perhaps someone else might know.
Should the 0 be away from or against the corecell or doesn't it matter? Perhaps it matters for the exterior parts more than interiors. When I place the 45 against the corecell; the failure early before a long cure time seems to be on the 90 degree delta (or between the 45s).
I am using a surfacing veil (now) as well. The veil seemed to like to combine more with the 0 strands which likened to cause more ability even still for shear between the 45s. But if I placed the 45 next to the veil, it might like to shear even more as the 0 strands would be further inside the laminate.
Is there a general rule I missed?
Lots of ways to look at things, but the 0 strands on the outside of the matrix probably make the most sense, unless there is something counterintuitive.
To complicate this a bit more. If you were going to double the fabric, would you end up modifying the approach? I might double my hull laminates on the exterior at a cost of 50# per hull.
tia
Should the 0 be away from or against the corecell or doesn't it matter? Perhaps it matters for the exterior parts more than interiors. When I place the 45 against the corecell; the failure early before a long cure time seems to be on the 90 degree delta (or between the 45s).
I am using a surfacing veil (now) as well. The veil seemed to like to combine more with the 0 strands which likened to cause more ability even still for shear between the 45s. But if I placed the 45 next to the veil, it might like to shear even more as the 0 strands would be further inside the laminate.
Is there a general rule I missed?
Lots of ways to look at things, but the 0 strands on the outside of the matrix probably make the most sense, unless there is something counterintuitive.
To complicate this a bit more. If you were going to double the fabric, would you end up modifying the approach? I might double my hull laminates on the exterior at a cost of 50# per hull.
tia