1972 StarCraft 18' SS transom replacement

Discussion in 'Projects & Proposals' started by Kelly56, May 17, 2019.

  1. Kelly56
    Joined: May 2019
    Posts: 2
    Likes: 0, Points: 1
    Location: Utah

    Kelly56 New Member

    Newby here! I removed all screws, bolts, nuts, drain tubes, etc. for replacing The transom with new marine grade 3/4 plywood. I can't get the transom out. Any ideas? thumbnail_20190517_153249_resized.jpg
     
    Kelly56, May 17, 2019
    #1
  2. Mr Efficiency
    Joined: Oct 2010
    Posts: 10,386
    Likes: 1,050, Points: 113, Legacy Rep: 702
    Location: Australia

    Mr Efficiency Senior Member

    Is it sandwiched between two pieces of aluminium ?
     
    Mr Efficiency, May 17, 2019
    #2
  3. Blueknarr
    Joined: Aug 2017
    Posts: 1,497
    Likes: 445, Points: 83
    Location: Colorado

    Blueknarr Senior Member

    Can we get a pic of the inside?
    Why the transom replacement?
     
    Blueknarr, May 18, 2019
    #3

  5. Kelly56
    Joined: May 2019
    Posts: 2
    Likes: 0, Points: 1
    Location: Utah

    Kelly56 New Member

    Thank you for the replies. I am replacing the transom because it is warped also, it's 47 years old. I got it out in one piece. I used WD-40 where it was bolted up between the aluminum. A little prying on each end and she popped free. It was wedged in tight from all the swelling from water. I also replaced the floor with new plywood and sealed all edges and both sides. Next I will cut out the new transom, it will also be sealed before re-installing. This is on a 1972 StarCraft 18' SS aluminum hull.
     
    Kelly56, May 18, 2019
    #4
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.