Aqua Lark hull repair

Discussion in 'Powerboats' started by Doyle33, Nov 7, 2021.

  1. Doyle33
    Joined: Aug 2021
    Posts: 4
    Likes: 0, Points: 1
    Location: Northern Pa

    Doyle33 New Member

    I bought an aqua Lark over the summer to be a winter project. Once I split it in half under the seat was thin and had holes. Any pictures of how they are built under the glass? I read a earlier post pretty much asking the same thing but no responses. Any advice would be greatly appreciated. Tia, Todd
     
  2. bajansailor
    Joined: Oct 2007
    Posts: 3,596
    Likes: 1,560, Points: 113, Legacy Rep: 37
    Location: Barbados

    bajansailor Marine Surveyor

  3. Doyle33
    Joined: Aug 2021
    Posts: 4
    Likes: 0, Points: 1
    Location: Northern Pa

    Doyle33 New Member

    I believe mine is a bit newer. It's a two piece boat,the hull and top are separate,riveted together. The seat is molded in the top part. I started pulling up the old fiberglass. Wasn't any wood left. I'm currently pulling out the foam. Thanks for posting .
     

  4. Ike
    Joined: Apr 2006
    Posts: 2,677
    Likes: 477, Points: 83, Legacy Rep: 1669
    Location: Washington

    Ike Senior Member

    you might want to watch this video on youtube These boats were used by Disney and others. Do a search on Aqua Lark and you will find quite a few hits.
     
Loading...
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.