the brain

I only have one more hole to add more negative trim for hole shot improvement. I may test it out. I have received my brand new...

You know the previous engine 04 Johnson175HP trim limiter rod is in exact same position upper row closest to pivot point. however...

OK will pump some evinrude triple guard grease in tilt shaft. will check trim motors oil is it filled to top just under close cap...

I recently replaced my OMC trim gauge w/ a VDO designed for Evinrude. When engine is trimmed in all the way in down position the...

my solas 19 (now relegated to a spare stowed) has much more fin surface than the Viper 22. how does fin surface factor in? my viper...

to clairify when I floored her an the prop was spinning but vessel wasn't moving much basicley churning an RPM shoot up to just over 6K...

OK I'm learning more about prop.s thanks Jehardiman for explaining. when I did these shakedown runs I keep the engine trimmed in for...

baeckmo are you saying I should lower my wide open throttle from 5850RPM during my testing? and I can increase pitch to 20" thanks for...

HelmutSheina hope your feeling better today. the cavitation burns you mention where actuely pointed out to me on another forum. I was...

Please advise on prop. Selection an desired WOT RPM for a 2012 ETEC 175HP gen1.I believe 5850 (consulting experts bc I'm not sure.) is...