True enough for a dynamic analysis. However, short impulse peak pressures will not necessarily transfer much energy to the structure if the...
Well, I would use pressure sensors in a combination with strain gages and linear displacement sensors to find out the minimum timeframe relevant...
Yes, I do need to measure dynamic pressure, however, I would use the readings from multiple sensors on one panel to average the pressure used in...
as a suggestion, so if I was to put 9 small holes (or more for that sake) to a panel on the hull and have all these holes connected up and share...
Thank you for that reply. Well said, I need an absolute dynamic pressure sensor with temperature compensation. What you think should the...
I think this is more suitable for steady-state tests. I am looking for an accurate way to measure pressures when driving at high speeds into waves...
Basis for quasi-static structural calculations. Ultimately the goal would be to see if one could use lower panel pressures than the standards dictate.
Thank you for this interesting input. I see only one problem with these sensors, though I would love to use them for their small size and...
Well, ideally the sensors would mount on the outside. Then it would be easier to sell the boat to end user after trials. However, drilling holes...
I know there is an old thread with the same name. It is too old to reply to. anyway, I am involved in a project where we need to make pressure...