I wish I shared your optimism for the market, but having lived through the crash of the late 90s as well as the 15/16' one this is much more like...
Cnf in Mississippi does nozzles. He's significantly less cost than west coast makers. In the last couple years he's done some for a southeast...
Hard chine millenium hull? Keep in mind you gain some thrust with the nozzle but would also loose with much smaller diameter prop. A 28 inch...
Its off brand coosa, Coosa is a lot like plywood in physical characteristics, although ply takes a fastener a bit better. That and ply is way...
Curious what hull you have. This is the light/loaded conundrum facing all seiners. Overwhelming percentage of our boats were built before our...
I have a table top that has a thick chunk of virgin tivar uhmw sheet. One side was smooth, we did a light sand of a burr or two and then a light...
Pod drives may be hard to trailer, and might be the only form of propulsion with a more questionable track record than outdrives. While awesome in...
I'd be looking for a big old DC charger like the old tombstone welder style ones Nampa used to sell. I've seen that pronounced electrolysis a...
We deal with the double edged sword of tunnels, helps us get shallow but makes a balancing equation of "least worst ". I've seen guys go 5 blade...
Guessing the ob to all other propulsion methods us 90:1 for what we'd call a pacific northwest special. Haven't seen a surface drive on one for...
Have little knowledge of big boats, but have been involved in accident diagnostics for small boats. Overwhelming majority are some fairly...
What is the data plate maximum on the engine rpm? Usually companies shoot for a percentage over max rated rpm. Often times it makes them under...
Good to know. I've room for a much bigger thruster with a shorter tunnel in my skeg.
Fair point under the shaft, definitely cleaner and deeper than transom mounted. Think those are all hydraulic, and way outta the bilge. I'll...
Cabling is pretty easy to run anywhere, just some stainless and a tube bender. Just seems like it's near the worst place for introducing a...