Barry

What is wrong about my statement? The boat will plane at a determined speed, regardless of the gear ratio. If it can't reach that...

They dont send any signal. Its simply a variable resistor to ground. Potentiometer Reostat. I see your saying your water tank is...

There are several boat manufacturers using the poly D shaped collars. I had seen one at the Seattle Boat show quite a few years back and...

To Baeckmo A question The question of drag from a completely ventilated transom has come up on different topics. I am curious what the...

The advantages of a stepped hull is a reduction of wetted surface area/drag and the introduction of another stagnation line, ie the...

Surface piercing propellers are designed to ventilate, therefore they don't cavitate.

I was under the impression that the step continues to the side of the boat and would normally be vented on step

This is a better look at the process. You would not need the elaborate bladder mechanism with the wheels

With the mast off, do you have access through the bottom of the mast? There are two possible goals here 1) fill the holes for appearance...

Inflate your tubes to the maximum recommended by the manufacturer. Certainly the aluminum floor is rigid but it appears that some of the...

Thanks for the picts. I have never seen these sleeves before

@tropostudio beat me to it. Here's another - high angle rod ends. But there are other problems here and I think you need to rethink the...

SolGato nailed this. So the interior rotating piece, which looks like a ball bearing with two horizontal surfaces. The horizontal...