Well all your advice makes perfect sense, especially as seen during my failed test runs. Much appreciated. I will use hardwood and over drill the...
There are two overhead voids needing to be filled under the deck and directly beneath the bow cleats. These voids remained after prior deck...
The N.A. advised to attach the beam to the hull walls (as well as to the underside of the deck). Other than those connection points, the beams...
Thanks for the very helpful advice and info. The beam is part of structural reinforcements needed after taking out a large rhode channel void,...
Any pro laminators on here who could chip-in on how they would go about laying this beam up? From a few practise runs, I found that the initial...
I am building a transverse beam out of fibreglass with not a lot of laminating experience. I will be laying up the beam on a waxed piece of...
Could the switch hole be laminated first using the biggest bevel possible, then the rope channel void patched afterwards with the largest bevel...
On Mr 'E's idea of laying up a span across the whole above deck area, would this in effect create a uniform deck strength and eliminate any...
Thanks for the idea of laying up the above deck area first. How would you then go about eliminating/filling-in the rope channel void and switch...
Hello all - first post here. After much research with no clear answers, I'm hoping to gain the members knowledge and experience on the below. How...
